Clark forklift Fault Codes. service Manual

Clark TMX 12-25 EPX 16-20s Service Manual. Fault codes (193page.) Download

Diesel or LPG Engine Pneumatic Tires: CMP50 CMP60 CMP70 CMP50 Download

Clark ECX20-32 EPX20-32 Service Manual Download

Clark SM-615 ECG 20-32 Genesis Series Truck Service Manual Download

The EVTlOOiX"tiontro~ is':'capabie of storing up to 16 Status Codes'along with

the Battery Condition and the Hour Meter,Reading at the time status code

was recorded. The control will only store a status code that will cause a .

PMT -or the,-82,'and/or, ~83 codes that are 'a result of the drive motor being

stalled. :. '.

The last status code to occur can be accessed by itself, without the

battery condition or hour meter by accessing the Function #l register.

Use the following procedure to access the last 16 stored status codes:

1. Turn the Key switch to OFF and disconnect the battery receptacle.

Turn the Key switch to ON. The Line contactor should energize and

the seat belt warning signal should sound until the capacitors are

discharged.

Warning: Never plug or unplug the 'Yr connector of the harness or the

Hadset f&rn~he oscillator card unless the battery has been

disconnected and the 1C capacitors discharged.

Remove the 'Y' plug from the oscillator card and insert the

handset 'Y* connector into the card.

Reconnect the battery receptacle but leave the key switch in the

OFF position.

Depress the 'CONT' and 'ESC' buttons on the handset

simultaneously.

The handset will now display a two digit Status Code. Record this

status code on the EIVTlOOZX Status Code Worksheet in the Flag #18

status code box.

Depress the 'CONT' button on the'handset. The handset will now

display a three digit battery state of charge for flag #18. Record

this reading in the Flag #18 Battery Condition box. L

Depress the,'CONT' button on the handset. The handset will now

display a four digit hour meter reading for flag #18. Record this

reading in the Flag #18 hour meter box.

Depressthe 'CONT' 'button again. The handset will now display

two digit Status Code. Record this reading in the Flag

#20 Status Code box.

Each time the 'CONT' button is depressed the handset will display

the next bit of information, 2 digit status code, 3 digit battery

condition, and 4 digit hour meter reading. Continue through this

sequence recording the displays on the worksheet until all the

boxes are full. The display will go blank with the next depression

of the 'CONT' button. To review all 16 Flag positions again,

depress the 'CONT' and 'ESC' buttons simultaneously and flag #18

status code will reappear. You must continue through the entire 16

Flag numbers before the display will go blank again.

When all the information is recorded.on the worksheet, turn the

Key switch ON. With the Park brake applied (-01 displayed on the

handset), depress the 'CONT' button to enter the programming mode

(8888 displayed). Now depress the 'CONT' and the 13 button

simultaneously to access Function #28.

The,handset will now display the 'Last Fault Flag' number. This

number tells you that the next memorized status code, along with

the battery condition and'hour meter reading ,at the time of the

status code, will be inserted into that Flag'Nuxqber. Record this'

'number by circling the corresponding Flag Number on the worksheet.

The Last Fault Flag Number tells you that the last stored status

code is the one previous to the. circled Flag Number.

Code -01

Code -02

Code -03

Code -05

Code -06

Code -07

Code -08